Step 1 - Wash your hands, glasses, and Stick on Readers Lenses with plain Original Dawn Dishwashing Liquid (no lotions-no oils) with warm to hot water so you can remove any dust, dirt or oils. Rinse thoroughly with clean warm to hot water. Never use any type of soap containing lotions or oils as this will damage your new magnification lenses and will prevent the lenses from sticking at all. 






Step 2 - Using clean warm to hot water, apply the lens to the inside lower half of your glasses. Proceed with one lens at a time. Position each lens so the curved side presses down. Our Suggestion: 2 1/2" apart; although they may be applied anywhere on the glasses to suit your own personal needs.  







Step 3 - To check for proper placement, put on your glasses and look through your Stick on Readers Lenses. Placement adjustments are easily made by sliding your lenses around while they are still wet. You will want to press out most of the water and air bubbles before you dry them with the mere press of a finger or roll of your thumb from one side to the other; BUT leave a little water underneath each lens. This is part of the adhesion process. The water acts as a wick and wicks the remainder of the water away over a period of several hours.  Note: Your vision through the lenses will be blurry until they have completely dried. This is completely normal and part of the "Hydro Tac" Bonding Technology process. Raise your glasses up and let all the loose water fall away. 

Step 4 - When properly positioned, press the excess water gently to the sides with a roll of your thumb. Pat dry with a lint-free towel or tissue. Allow the Stick on Readers Lenses to dry completely before using. Set them aside. This usually takes 12 to 24 hours for proper drying time. This process is part of the "Hydro Tac" Bonding Technology that creates the adhesion. Stick on Reading Lenses are removable and reusable and can be reinstalled by repeating these simple, easy to understand instructions. Repeat these same instructions if removed.